1967 C10 LWB

1967 C10
- 350 sbc, Runs great, new water pump, new power steering box
- TH400 built by Steve's Transmission to hold 800hp
- Gear Vendor overdrive
- New Hurst
- New Heavy Duty Drive line
-New Lowering springs rear 5"
- New Lowering spindles 3" 6x5.5 wheel pattern
- New front Disc brakes
- New Tubular upper and lower control arms
- New front and rear springs
- New ball joints, tie rod ends, idler arm, power steering box
- New power brake booster and master cylinder
- New body bushings
- New Rear Trailing arm bushings
- New rear Sway bar Bushing
- Bucket seats out of 72 Blazer

-Dynamat padding floor and rear of cab

When I say new I mean this installed new a couple of years ago and been sitting. Truck has less than 2000 miles on parts and rebuild of transmission. Truck had a 600 hp big block and everything was built to handle up to 800hp. I built the truck and it sat. I sold the big block and install a good running 350 with headers and new exhaust.

The truck has rust in the rockers, in the bed and (1) front inner fender. Cab corners and everything else solid.I have replacement rocker that will go with the truck.

The truck was bought from Chevrolet black w/ green interior. I know that's weird but it's on the build sheet in the glove box. It was also ordered with under the dash Frigid Air system also on build sheet.

Body lines on this truck are straight and clean. Some paint and little rust repair it would be a gem.

I bought the truck from the 2nd owner.