1965 ford mustang gasser

1965 mustang gasser project was 6 cyl. very good shape for 1965 no undercarrige rot just surface rust only drivers side front floor had small rot but put new full side floor witha 1971 mustang 351 Cleveland 2 barrel engine standard bore with 4 barrel edelbrock 2v intake motor had 43,000 then just set car was in accident then sat and rotted I put new main and rod bearin, gaskets, seals, new compcam mechanical cam and lifters with .540 lift motor was run only to break it in roller rockers, front straight axle out of 1958 f100 with 68 mustang rotors, disc. brakes, rear end is 8 inch open don't know gear ratio was going to put nine inch it still has clutch pedal and ball bracket on frame for z bar just little rot near front of rear wheels rocker a panels all good trunk floor good front frame all redone with steel from firewall all the way to fron, no shock towers very solid car I know didn't tell everything please ask question small hole in cowl but was going to fill vent in because it's a gasser don't matter LOOK AT PIC'S ASK QUESTIONS

HAVE ALL GLAS, INTERIOR, NEW RUG, MOST CHROME VERY GOOD DASH PAD GOES WITH CAR, FORD, HOTROD, MUSCLE CAR 1965-70 SHELBY, 1966, 1967, 1968, 1969

p.s.HAS Shelby gauge pod, side scoops, hood scoop and someone started make Shelby truck spoiler

selling for my son I'm retired so have time title is clear and in his name

On Dec-15-16 at 03:22:25 PST, seller added the following information:

ENGINE has 43,000 miles out of 1971 mustang new water pump, new chrome fuel pump, new chrome one wire alternator, has holley 650 double pump carb, new rod and main bearing, new seals and gaskets new high volume and presser oil pump

the 71 mustang the engine came out of was crashed in late 70's and parked then body rotted that why low miles

someone started to form shelby trunk spoiler

On Dec-16-16 at 13:06:02 PST, seller added the following information:

will help load car will yard drive to load on truck to ship and has nice gas tank and new sending uint