1972 chevrolet chevelle true ss454

THIS IS A TRUE 1972 CHEVROLET CHEVELLE SS 454

LIST OF NEW PARTS ARE AS FOLLOWS

EVERYTHING FROM FRONT TO BACK & TOP TO BOTTOM

COMPLETE FRAME OFF ROTISSERIERESTORATION

BOTTOM OF CA, FRAM, ALL SUSPENSION PARTS & REAR END HAVE ALL BEEN PAINTED WITH BASE COAT CLEAR COAT BLACK FOR THAT SHOW QUALITY SHINE

THE EXTERIOR PAINT COLOR ISCRANBERRY RED WITH BLACK STRIPES & THE CAR WAS DISASSEMBLED, THEN PAINTED AND REASSEMBLED

ALL BRAKE LINES, FUEL LINE, EXHAUST AND FUEL TANK ARE STAINLESS STEEL

COMPLETE NEWINTERIOR : INCLUDING TWO COATS OF PAINT ON FLOOR & THEN COVERED WITH DYNAMAT TO HELP WITH ROAD NOISE & HEAT

ENGINE COMPARTMENT ALSO PAINTED WITH BASE COAT CLEAR COAT

THE 454 ENGINE HAS BEEN COMPLETLY REDONEWITH ALL NEW PARTS INCLUDING A 496 ROTATING ASSEMBLY, WITH NO EXPENSE SPARED

TURBO 400 TRANSMISSION WITH 2500STALL

ALL NEW BODY & SUSPENSION BUSHINGS, BALL JOINT, TIE ROD END, CENTER DRAG LINK AND IDLE ARM WITH MOOG PARTS

17 & 18 INCH WHEELS AND TIRES THAT ARE ALUMINUM RALLYS

THIS PROJECT WAS ACOMPLETE NUT AND BOLT RESTORATION THAT TURNED OUT TO BE SHOW QUALITY JOB AND HAS ZERO MILES ON EVERYTHING

THANKS FOR LOOKING AND FEEL FREE TO ASK QUESTIONS IF YOU ARE REALLY INTERESTED BUT PLEASE DO NOT WAISTE MY TIME OR YOURS

On Jul-17-16 at 20:11:34 PDT, seller added the following information:

ENGINE PARTS LIST

SCAT BALANCED & BLUEPRINTED 496 CI ROTATING ASSEMBLY WITH H BEAM RODS & WISECO PISTONS

LUNATI CAMSHAFT AND MATCHINGVALVE SPRINGS

CLOYES BILLET TIMING CHAIN GEAR SET

COMP CAMS ONE PIECE PUSH RODS

COMP CAMS ULTRA GOLD ROLLER ROCKERS 1.7 RATIO 7/16 STUD

BILLET TIMING COVER

EDELBROCK PERFOMER RPM AIR GAP INTAKE BLACK COATED

HOLLEY ULTRA DOUBLE PUMPER 0-76850 BK

MSD READY TO RUN HEI DISTRIBUTOR

THIS IS A PUMP GAS MOTOR AND EVERYTHING IS BRAND NEW

On Jul-22-16 at 20:05:40 PDT, seller added the following information:

THIS IS A TRUE 1972 CHEVELLE SS454

AS YOU CAN SEE THE FIFTH DIGIT IN THE VIN# IS (W) WHICH CONFIRMS THAT THE CAR CAME WITH A 454 ENGINE AND ONLY AVAILABLE IN THE SS MODELS

ALSO TO ANSWER A FEW QUESTIONS I HAVE HAD ABOUT THE CAR

FRAME, UPPER & LOWER CONTROL ARMS, SWAY BARS, TRAILING ARMS, 12 BOLT REAR END HOUSING, TRANSMISSION CROSS MEMBER & DRIVE SHAFT ALL GOT SAND BLASTED TO BARE METAL THEN SANDED SMOOTH BEFORE EPOXY PRIME, BLACK BASE COAT & CLEARED WITH PAINT JUST LIKE THE OUTSIDE OF THE BODY.

UNDER SIDE OF BODY / OUTSIDE OF THE FLOOR PAN AND TRUNK ALSO SANDED TO BARE METAL BEFORE EPOXY PRIME, BLACK BASE COAT & CLEAR COATED.

DUPONT CHROMABASE WAS USED FOR THE RED & THEBLACK STRIPES ON EXTERIOR PAINT, THEN CLEAR COATED WITH A HIGH GRADE CLEAR.

NEW WIRING HARNESS UNDER THE HOOD INCLUDING HEAD LIGHTS AND SIGNAL LIGHTS

ENGINE WAS ALSO PAINTED WITH THE EXTERIOR RED BASE COAT & CLEAR COAT, TRANSMISSION ALSOPAINTED BASE COAT CLEAR COAT SILVER

BRAND NEW SHORTY HEADERS ALSO JET COATED SILVER

INSIDE THE TRUNKALSO HAS BEEN CLEAR COATED.

EVERYTHING INSIDE AND OUT WORKS RIGHT DOWN TO THE CLOC, CIGARETTE LIGHTER, GLOVE BOX LIGHT, HORN, REVERSE LIGHTS & NEUTRAL SAFETY SWITCH.

ALSO IF YOUARE A INTERESTED BUYERAND CONTACT ME I CAN SEND YOU A VIDEO CLIP OF EXTERIO, UNDERSIDE AND THE ENGINE RUNNING.

THANKS FOR LOOKING !!

PAYPAL ACCEPTED FOR DEPOSIT ONLY!!!!!!

ONLY CASH OR CERTIFIED FUNDS FOR THE REMAINING BALANCE!!!

ALL CERTIFIED FUNDS MUST CLEAR THE BANK BEFORE CAR IS RELEASED!!!