C10 Custom Big Back Window SWB Fleetside 350 High Performance 12 bolt rear

Make: Chevrolet
Model: C-10
Trim: C10 Custom
Year: 1965
Mileage: 100
VIN: C1445A------
Drive type: Automatic
Vehicle Title: Clear
Item location: United States
Extras

Listed by
Private seller
Enquire

Description of 1965 Chevrolet C-10

Here is a 1965 C10 Custom. big back window. short wheel base. factory automatic. nbsp;and it is a fleetside truck. The title is free and clear. This truck has been sitting for many years. It was pulled to the side and parked because of an ignition issue. It will need to be restored. This C10 Custom has a high performance 350 engine. Accell Super Coil. dual point racing distributor. nbsp;headers. dual exhaust system. and a turbo 400 automatic transmission. I wanted to start it up to make sure it would still a run. I got tired of trying to adjust the racing ignition system and wrestling with the old Holley carb. I was alone during this process. After almost getting frustrated I pulled the distributor and replaced it with the HEI system from my 454 engine. She fired right up. The engine still runs and she did not smoke up the garage. That Holley carb may need replacing or at least a Holley expert to get it right. I believe with some tuning up and point replacement you will be very happy with this drivetrain. I will remove my HEI distributor once you hear it run and reinstall the racing dual point distributor inside the engine if you would like for me to do so. I think it probably just needs new dual points to be back up to par. but I was short on time today. I couldn't thoroughly check it out. I believe the Super Coil is the culprit for the problems. There are no brakes on the C10. Radiator. engine. transmission. driveshaft. and rearend are all presently hooked up. Back in the day a sunroof was added to the roof. I have cut the roof off of another C10 to put it back stock. There is an indentation in the front. but it can be used to make the repair. The rockers. floors. bottom of the doors. and lower rear of the fenders all need replacement panels. The cab corners are pretty decent shape. They need very minor attention. The bed wood strips and wood will need replacing. There was a piece of plywood serving as a bed floor. Mother nature defeated it. The tailgate is in very good shape. The frame is good and straight. The wheels could be polished. You would need new center caps. All of the glass is good. Please see the photos. Please ask any and all questions that you may have prior to placing any bid on this C10 Custom. Please make sure you have the cash in your possession to back up any bid that you place on this C10 Custom. Your deposit must be received within 24 hours after the auction ends. Please make arrangements in advance. I can be reached at (770)262-8663 if you have any questions at all. You do not have to guess about anything. I will give prompt and honest answers via email or phone. Just ask if you are in doubt. I am in Duluth. GA 30096. I am just north of downtown Atlanta. GA off of I-85 North. I will assist you or your transport company with loading this vehicle. If you have it shipped I will send you photos of the loaded truck when it leaves my possession. I will take care of you on this end. Please only bid if you are capable of completing the transaction. Thanks and happy bidding. Good luck!