1969 C10 CST 396 4-Speed Fresh 396, less than 30 miles since rebuild. Mild cam, Electronic ingition, alum. Intake, Edelbrock Carb. New Aluminum Radiator with 2 Electric fans. Aluminum water pump. Power Steering. HD Munice SM-465 4 speed with a new 11" Zoom clutch 12 bolt limit slip "Pos" Read end. 3-1/2" Drop spindales in front with Power disk brakes in front and drum in the rear. New under the bed gas tank. Factory Tach that usually does not work Oak bed floor with polished stainless steel strips that is approximately 7 years old. Reese hidden hitch that is located behind the tag. Battery was new last Fall No Air Conditioning Long bed Savage Rebuilt Title "Inspected by and passed by NC DMV" I have owned this truck for a little over 10 years Previous owner said that this truck was involved in a front end crash sometime in the late 1970's and was parked until around 2005. He replaced the drivers side front fender, Front Bumper and grill. Then last year, I bumped into the front of my carport and redamaged the parts. The bottom of the doors are rustic and need new replacement panels welded in. The seathas a large cut in it and holes in theVinyl. The panel underneath the pass. Needs a new panel welded in, I have a new panel that goes with the truck. Power Steering pump drips fluid. I replaced the pump with one from Advance Auto and it leaked. Advance auto replaced it for free and the 3rd pump leaks. Now I just check the fluid level before driving. Last year I rebuilt the 396 engine, had it bored out .030. So now the cubic inches = 402. Crankshaft was turned .010 - .010. All internal parts except the Rod's were replaced. Doors shut almost like a new truck and the transmission shifts like a new transmission. I was planning on painting the truck this year but I have been working so much, that I'm not able to find the time. Therefore, you are able to see any areas that need to be repaired and paint the truck the color of your choosing instead of purchasing a truck that has been just painted and hiding the body repairs.
The Shipping details of EBay's software does not allow me to put in the following info: Shipping is Available for a $30.00 loading fee and $1.00 permile from my address. my Zip code is 28650. Or you may pick the Truck up for free after I receive your payment.
|