Rare 1976 Datsun 280z Mechanically restored 2 seater coupe

Make: Datsun
Model: Z-Series
Type: Coupe
Year: 1976
Mileage: 82171
VIN: HLS30-311683
Color: Blue
Engine: 2.8 L
Cylinders: 6
Fuel: Gasoline
Transmission: Manual
Drive type: RWD
Interior color: Black
Drive side: Left-hand drive
Vehicle Title: Clean
Item location: Los Angeles, California, United States
Extras
Air Conditioning
CD Player

Listed by
Private seller
Enquire

Description of 1976 Datsun Z-Series

pinion rebuilt. I had the Nissan dealer go over the car and adjusted the valves after the engine was rebuilt. It has had a complete suspension overhaul including strut rod bushings, sway bar bushings, front and rear control arm bushings, transmission mount, and clutch, master cylinder, slave cylinder, the rack & pinion and mustache bar . The original 4 speed transmission has been replaced with a 5 speed. It has the same gear ratio as the original 4 speed but the 5th gear is overdrive. The edge of the front of the hood is dented on the driver side and it needs to be straightened and realigned which is a simple repair. You can see the bumper on the ground I was planning to have it straightened and re chromed. The rubber fillers on the bumpers are cracking. I will be updating this listing after I get the car cleaned up. Also will be providing the Vin# in a few days. The carpet has been replaced and is in good condition, the headliner has been replaced and is in excellent condition, the rubber around the stick shift has been replaced and is in excellent condition. All of the rubber seals have been replaced and are in excellent condition.Drives and handles like new. The driver side inside door panel is off but I have it and it is in good condition. It needs new right and left mirrors. The engine has full power and run smooth and quiet. I pulled back the seat covers so that you can see that the seats are in pretty good condition. The car is very dusty from sitting, I'll be doing maintenance and servicing it until it is sold. I have a new ignition key switch which I have not yet installed, it is very simple, only 2 bolts and plug it in. I have only 1 can of R12 for the a/c unit.