Home / Dodge /

1970 Dodge Charger 500 vynile 2-Door 7.2L

Make: Dodge
Model: Charger
Type: Hardtop
Trim: 500 Hardtop 2-Door
Year: 1970
VIN: XP329LOG138276
Color: PRIMER BLACK
Engine: 7.2L 7211CC 440Cu. In. V8 GAS OHV Naturally Aspirated
Cylinders: 8
Fuel: Gasoline
Transmission: Automatic
Drive type: U/K
Vehicle Title: Clear
Item location: Goodlettsville, Tennessee, United States
Extras
Air Conditioning

Listed by
Private seller
Enquire

Description of 1970 Dodge Charger 500 Hardtop 2-Door

I have had this car since 2014 and as far i know there has only been two owners on the title possably three.This is a very sound restoration car as i have been told by a number of people including a classic car dealer that knows the car,the person i bought the car from and the orignal owner.The car lot is maple motors located in hendersonville,tennessee.i have cut the rust out that i could see and there didnt seem to be and cancerous rust and i have put resien on most of the areas that i have started to repair to keep the rust from damaging anything else.The underside of the car has been blasted and panited except for tyhe areas that need to be replaced.The body work that needs to be completed is as following to my knowledge:hood,floor pan,trunk pan and rear lower quarters need to be patched as you will see in the pictures i am going top post.The interior needs the carpet,wiring work rewired and door panels and everything placed back together.The motor,all that needs to be done to be able to start the car is as follows:The motor wired back up,the raidaiotor bolted back up alond with the provided new hoses put on,the new eletric cooling fans placed and wired and the sparkplugs,belts be put in,now the other part of the motor that needs to be found is the a/c condencor and a/c hoses,the headers need to be heat wrapped and placed back in and the heat wrap will be provided to,the exhaulst need to be put back in,the transsmission and starter need to be tightened up aftert the exhaust is placed back in and the drive shaft and gas tank need to be bolted back in and then at that point you would be able to start the car,now other motor parts i have replacedc also is the master cyclender and torqe converter.as far as everything else i have placed inside the car to keep it together and i also have a master dodge manuel to go with the car that covers dodge cars from 66 to 70
I will not be paying or covering the shipping or any other fees that is required of the buyer such as shipping,warrenty,inspection,i am only paying for this auction so anything else outside of that is on the buyer to handle!!!!!!!!!!!!!