|
1990 Mustang LX 5.0 NASA American Iron Track-Day CarThis is a turn-key track day car with a newly rebuilt motor. It needs only a driver. Between myself and the previous owner, e have $25,000 invested in it.I really loved tracking this car, ut I recently bought a Z06 and already have third track car, o this one has to go.The handling is precise and adjustable with just a little throttle modulation. It goes right where you point it. The handling is also totally forgiving, nd the car can be drifted at will. The car sounds great, t's fast, nd I can guarantee that it will turn low 1:34s at Willow Springs.The motor is just rebuilt with less than 50 miles. I have not had it on a dyno, ut it should comfortably make 400 hp at the flywheel. The motor was built by Gear Driven Automotive, nd much of the other work on the car was done by Wild Pony Motorsports.The car is available for test drives here in Santa Monica. If you can show proof of track experience, hen a few test laps at Willow Springs Raceway is a possibility.Condition: mechanically the car need nothing other than that the new motor should be run in a bit more, nd the car should get a dyno tune. The car looks nice and I get compliments, ut this is a race car, ot a show car, nd although these photos hide some of the defects, f you were to look up close you could see imperfections in the paint like door dings, ater spots, nd paint chips. The car has never been crashed and has never seen any rust. The interior is what it is—again it is not a show car, nly a track car. The wheels have some bends visible on the inside of the wheel, ut there is no vibration in the wheel. Tires are about 75%.Engine: I don't work much on my own car, o for all the details I can have you speak to the engine builder.SVO ford racing Sportsman block .030 over bore with a torque plate. Crank eagle 4340 forged steel. Eagle rods 4340 forged steel H beam with 8740 cap screw rod bolts ARP. Custom main girdle with ARP main studs. J&E pistons. Edelbrook RPM aluminum heads with Manley stainless steel valves and chrome molly retainers and .010 degree keepers, ustom 5 angle valve job. Roller Rockers, ord Racing full true roller rockers 1.6 ratio. Miloden 7qt. road racing pain. Long tube headers.Transmissionanddiff: Tremec T56 six-speed. Torsen differential.Brakes:Griggs Racing rotors and calipers (front and rear). Motul 600 racing brake fluid. Stainless steel lines. Hawk HT-10s. Brake proportioning valve.Suspension: full Griggs road racing suspension: tubular K-member and double wishbone front suspension, atts linkage in the back, oil overs all around, djustable front and rear sway bars.GR40 Tubular K-member Billet Aluminum Steering Rack Bushings Griggs Racing Severe Duty Front Control Arms Front and Rear Coil Over Kit Koni shocks Griggs Racing Rear Control Arms Full Frame Kit included Upper and Lower Subframe Connectors and Bulkhead Stiffeners GR40 Billet Aluminum Bumpsteer Kit Torque arm GR40 Watts LinkageBody and interior: Autopower rollbar. Recaro racing seats with 5-point harness. Rear seat delete kit. Lightweight fiberglass hood and fenders. Rear-mounted battery. Momo steering wheel. 18- inch Fikse lightweight 3-piece wheels. Federal RSR 595 track tires (140 tread wear rating).Note that the Traqmate data and video logger shown in the photos is for sale separately. (This is a GPS-based system that tracks your lines on the track, peeds, egment and lap times, -forces, nd much more. It is incorporated with HD video.) I also have a bunch of small-block Ford performance parts for sale, ncluding several sets of headers, ictor Jr. intake, olley 650 carb, nd much more.THIS CAR IS NOT SMOG LEGAL IN CALIFORNIA. IT WILL NEED CATS TO MAKE IT SMOG LEGAL. THE NEW OWNER IS RESPONSIBLE FOR SMOG.Please email or call with any questions:310/709-5577. PLEASE DO NOT BID ON THIS CAR UNLESS YOU ARE FULLY COMMITTED TO BUYING IT. SORRY BUT I CAN'T ALLOW ANY BIDDERS WITH LESS THAN A 5-BID HISTORY. I REQUIRE A $500 DEPOSIT WITHIN 48 HRS OF AUCTION CLOSE. THANK YOU.
|
Home
Contact us
NEWEST CARS
SELL YOUR CAR
FAQ
Enquire
