75 Ford F250 8cyl 428cu. Automatic

Major Components: The truck has a D60 in the rear and a D44HD in the front (although the door tag and build sheet say it has a D60 up front but it just isn't so.)

Engine. It has a 360 engine that's been stroked to give it about 428 ci (I have no evidence that it has a 428 crank), and it goes anywhere in four-wheel drive. Engine was professionally rebuilt about five years ago by Bruce at Monkey Wrench. The stroke can be verified by sticking a dowel down the no 1 spark plug and setting the flywheel at TDC, which I've done.

More About the Engine. The previous owner told me that the truck had a 428 engine. Typically that means a 3.98 stroke and 428 crank, with about 0.060 bore over.

I am pretty sure this truck still has the original 360 engine block. It would be difficult to bore it over enough to make it a 428 through the same methods used for converting a 390 engine.

However, I have checked the stroke and it measures 4.125. IF it still has the same block, it could have been bored over just a bit (0.020) to clean it up...which would make it have displacement of about 429. If it wasn't bored over at all (4.05) it would be a 425.

Possibilities are 425, 428, or 429. One other possibility is that it has an even higher displacement, but chances are it's in the range of 428.

Transmission. It originally came with a three-speed manual transmission. This was converted to a C-6 automatic transmission...although the clutch petal and a few other items are still in place if someone wanted to convert it back.

Power Assist. The pump was replaced about four years so it's good. The Bendix power steering assist (a ram assist) components—the steering cylinder and control valve—were replaced this month, due to a leak at both components.

Sun Roof. It has a sun roof that opens, but it doesn't seal completely. I tried putting in new seals but if it sits outside and there a rain, when you move the truck about a half cup of water drops in the cab. Fixes are carry a rag, don't park it outside when it rains/put a tarp over it, get the seals fixed by a place that specializes in sunroofs, or cut out the section and weld in the metal from a junkyard truck.

Fluid Leaks? Nearly every vehicle this age has some fluid leakage. This truck and another 1970 truck I have do, but to the extent that even after a couple years there's still no discernible loss or need to add additional fluid. In the case of this truck it is at the transmission fluid pan.

Other Items:

It has shoulder restraint seatbelts that I properly installed (about five years ago)
New power steering pump
New steering assist cylinder and control valve.

Engine professionally rebuilt.

A cargo light.
Ranger XLT trim package
Rubber bed mat
New dash pad and dash cover (installed about five years ago)
Inspected and registered July 2017
Tires 98% tread (33" BFG All-Terrain)
From Albuquerque and very limited rust...surface and simply a solid truck.

If you are the winning bidder, put down a deposit, and come to pick up an don't believe this is worth the winning bid, I'll refund the deposit and we are done. I'm confident that it's