1935 Ford Coupe Hot Rod - 350 Chevy SBC, TH350 Auto, Subframe, Rack & Pinion

For sale is a 1935 Ford 5-Window Coupe Hot Rod.

This car is a lot of fun - it is quick, powerful, and drives at freeway speeds easily and smoothly. Previous owner refreshed the Small Block 350 in the vehicle and installed a cam. The frame was a "body-off" job from the previous owner - it has a big kick-up "Z" in the rear and a sub-frame in the front. The vehicle drives and brakes great. The glass-packs sound great, the car really has a good sound to it. Recently rewired the car, it is charging at full voltage at idle and keeps charging with all of the lights and other loads on. This car is an absolute blast as-is, but would also make a great Kustom with some rust repair and finish work.

Engine and Driveline

• 350 c.i. Small Block Chevrolet Engine
• Aftermarket Performance Camshaft
• Edelbrock 4 Barrel Carburetor with Gapped Intake Manifold
• "Ram-Horn" Exhaust Manifolds with Dual Exhaust
• Finned Valve Covers and Finned Ignition Coil Cover
• Glasspack Mufflers
• 90 Amp Chrome Alternator
• TH350 3-Speed Automatic Transmission
• Chevrolet 10 Bolt Rear End

Undercar

• Camaro Front Sub-frame/Clip
• Independent Front Suspension
• Manual Rack and Pinion Steering
• Front Disc Brakes
• Rear Frame "Z"
• Rear Drum Brakes

Interior

• Stewart Warner Gauge Panel
• Stewart Warner "Wings" Gauges
• 1952 Hudson Steering Wheel
• Driver Side Bearclaw Latch
• Needs Passenger Bearclaw Latch Installed (provided)
• No Side or Rear Glass (regulators provided)

Electrical and Lighting

• 90 Amp Chrome Alternator
• Converted Seal Beam Headlights
• Uses Conventional Headlight Bulbs
• Integrated Turn Signal Lights in Headlight
• Left and Right (Deluxe) Taillight/Brake Lights/Turn Signals
• Whole Car Recently Completely Rewired
• Fuse Block
• Relay Block
• Weatherproof Connectors

• Front Bumper
• Box with Window Regulators, Window Trim, and Bearclaw Latches

Wheels and Tires

• Ford 15" Steelies
• 5.50 x 15" Whitewall Bias Ply Tires

Needs

• Patch panels at rear quarters - one is tacked in, but other side needs replacement (small rust holes)
• Bottoms of doors need patch panels
• Trunk sill needs patch piece
• Rubs front left tire on hard left turns - rack likely just needs re-centering
• Trunk floor was cut out for the chassis "Z" - needs a portion of floor around the "Z"
• Needs a passenger door latch - will provide a bear claw latch to be installed if desired by buyer
• Needs rear and side glass - will provide some regulators that came with vehicle