1993 VR Mazda RX-7 Touring Coupe 2-Door 1.3L

Condition:	Used
Make:	Mazda
Model:	RX-7
Type:	Coupe
Trim:	Touring Coupe 2-Door
Year:	1993
Mileage:	107,200
VIN:	JM1FD3310P0202299
Color:	Red
Fuel:	Gasoline
Transmission:	Manual
Drive type:	RWD
Interior color:	BEIGE
Safety:	Anti-Lock Brakes, Driver Airbag
Vehicle Title:	Clear
Item location:	Van Nuys, California, United States

Extras

Air Conditioning, Cruise Control, Power Windows
Sunroof, Leather Seats, CD Player

Listed by

Private seller

Enquire

Description of 1993 Mazda RX-7

1993 Vintage Red Mazda RX7 with Beige Interior
This is a California car which has always been taken care of.
There are a few tasteful modification that were done to the car which include :

R1 Front Lip
Rear Skirts
1999 Spec Rear lights
1999 Spec Sunroof with glass as opposed to the car colored metal sunroof (original included)
Pettit Dual Tip exhaust (original included)
Pettit Aluminum AirSeparatorTank
Front Suspension Tower Brace
Engine lid stand removed, nd replaced with two struts.
Efini Y-Pipe
Triple Gauge pod (Showing water temp, il Pressure, nd Boost)installed in the center deleting the original tweeter. Display colors are white with the first click, nd perfect match orange on the second click.
JVC Head Unit with bluetooth connection which allows you to stream music from your Iphone. A microphone also installed for phone calls. Color matches the orange interior lights perfectly. Small subwoofer in the back hatch for a little extra bass. Sounds system sounds very good. Nounnecessaryor obnoxious wobble.
Power FC with controller unit running factory set-up. It has been suggested that the car be put on a Dyno to be tuned in order to last longer if it is to be driven hard.

The car currently has 107K miles on the chassis. In the last 5000 miles the engine was completely overhauled,solenoids, lutch, nd rear pillow balls replaced.
Engine Rebuild :

Goopy Resurfaced factory housings
Side plates lapped and re-nitrided (Chips Motor sports)
All new rotor bearings, tationary bearings, nd thrust needle bearings (Atkins)
New pilot bearing
Goopy 2 piece 2mm apex seals and new factory springs
All new side seals, orner seals & springs (Atkins)
New factory oil pump and chain
Atkins Thermal Pellet Oil bypass mod
FPD Damper mod
All hoses (coolant fuel and oil) replaced with new factory parts (Malloy Mazda)
All vacuum lines replaced with silicone lines
All New o-rings and seals
Factory injectors cleaned and flow tested by RC Engineering

Additionally I have a spec sheet if you would like to find out the technical numbers on the engine build.
The car runs, nd drives great!. The air conditioning blows ice cold.
The exterior is very clean with no major dents, r scratches. The interior is near mint condition.
Negatives :- The size of the wheels forces you to straighten the wheels when you enter a deep driver way. The previous owner had made a scuff in the top dead center of the driver side wheel arch. The paint has chipped, nd would need to be matched, nd rolled to be fixed.- The driver side rear wheel has a nail in it.- The windshield has a very small (1/3 inch) bullz-eye. It does not require any attention, s it has been this way for years.- Due to the modifications on this car this car will not pass smog in California. If you are planning on bidding on this car (and you live in California) you are taking that into full consideration, nd it is your responsibility to make thenecessarymodifications.
If you have any questions please give me a call on my cell phone, nd I will be glad to answer them. I used to work for a shipping company and can connect you to one of my old colleagues in case you need to have the car transported. Thank you for reading.
Yevgen (213) 308-4478.