1979 280SE Euro Import 86111 Mi W116

Make: Mercedes-Benz
Model: S-Class
Type: Sedan
Trim: 280SE
Year: 1979
Mileage: 86111
VIN: 11602412133038
Color: Blue
Engine: m110
Cylinders: 6
Fuel: 95 Octane
Transmission: Automatic
Drive type: RWD
Drive side: Left-hand drive
Vehicle Title: Clean
Item location: Joliet, Illinois, United States
Extras

Listed by
Private seller
Enquire

Description of 1979 Mercedes-Benz S-Class 280SE

1979 280SE Euro Import 86K Miles $6000

Location: Joliet, IL 60433


Good: Except AC (needs r-12 charge and new drier + oil) EVERYTHING works and can be driven and there is no sag in the front seats. Crank windows all work, car drives like a true w116. Fuel system total restored, with pristine fuel tank. Complete package. Locks have all been replaced with 3 Mater Keys and 1 Valet key.
List of work completed and parts replaced: https://mega.nz/#F!xEc2UYyS!zCgeapCdmAOrZwvQi_C66g!5IsWTahL
Videos + current + rebuild + prior owner: https://mega.nz/#F!xEc2UYyS!zCgeapCdmAOrZwvQi_C66g



-Original Becker Mexico Cassette (from 1980 450SEL USA) has been fully restored and internally upgraded. The cassette door springs were rusted out so the door was hot glued in place (from inside) as the cassette player is non-functional, and there is 1 crack on the glass from the right knob going bottom right. The radio has modern pre-amp outputs and an auxiliary input added to the back leaving the face plate intact. See photos here:

https://mega.nz/#F!NY80RKhI!N_22CEO6ULZJxbPWwX92BA


Bad:

-Valve steam seals blown, and head gasket possibly needs replaced. After seals blew stuck in traffic on the highway, car temperature spiked to 115c. Immediately cranked the heat to full blast and brought it down with 10-15 minuets to 100c and drove 45mins home. Oil leaks through valve cover breather hose and puddle of oil on the ground and oil in air filter. Vehicle holds at 80c on 40 degree day. Car has low torque starting from zero. Cooling system sealer would likely fix issue.

-The radiator should be flushed. ($200)

-The WUR needs to be cleaned or rebuilt again. Became clogged with fuel varnish after rebuilding entire fuel system. I forgot to clean out the fuel dampener. Fuel Distributor and Injectors should also be checked for blockage (although vehicle ran fine up to 85/90mph). Needs assistance starting by lightly pressing down on the air flow meter plate. ($360 rebuild shipped) You can see a very small amount to varnish build up https://mega.nz/#F!xEc2UYyS!zCgeapCdmAOrZwvQi_C66g?sYtUyCxS I highly recommend CIS Flowtech based out of Fairhop, AL http://www.cisflowtech.com/ They are the best professionals when it comes to these mechanical injections systems. I did clean out the varnish, but it has plugged up the internals of the WUR.

- No speakers in the vehicle, they were dry rotted when I purchased the vehicle, therefore removed.

- Steering column creaks when cold, goes away when warmed up (5 min) spare included in trunk

-Oil Sump screen is cracked new part included.


Parts Included:

Brand New Oil Sump screen

Brand New Oil pan gasket

Brand New intake gasket

Spare Front seat bottom (updated version)

Spare replacement grill

14 BP6ES Spark plugs

New Spare fuel filter

Original ignition wire set

Spare air filter

Spare New front rotors, rebuilt calipers and pads

Spare Blower motor

spare driving column

2 excellent condition exterior rear door handles

A full trunk of spare parts and + various w116 bits, pieces and components