/ /

1978 Ford Bronco Ranger XLT

1978 Ford Bronco

Condition: Used
Make: Ford
Model: Bronco
Year: 1978
VIN: U15HLAJ1441
Color: Red
Fuel: Gasoline
Interior color: Red
Vehicle Title: Clear
Item location: Spring Grove, Illinois, United States
4-Wheel Drive

Description for Ford Bronco 1978

1978 Ford Bronco in very nice condition. Sitting on a 9" Skyjacker lift with near new 38.5" Swampers on American racing 15"x10" aluminum rims. Motor and trans have both been rebuilt. Specs on the drivetrain are as follows:


400/engine balanced, lueprinted 10 to 1 compression, Crower hydraulic cam degreed in, od's were reconditioned and shot peened plus the beam's were smothed and arp bolts were installed, mall end's bushed, ead's were gasket matched on intake and exhaust side's, xhaust side's were polished, ompetition valve job, owl's blended, ombustion chamber's reworked and smoothed/, S Ferrea valves, -Motion valve spring's, oller rocker's, rane cam's teflon valve stem seal's installed, B clevland full floating piston's, hild's& Albert plasma coated file fit ring's, elling high volume oil pump, SD billet distributor, SD 6AL box and coil, edman headers with HPC coating, "mandrel bent exhaust with Flowmaster super 40's all ceramic coated, luidampr harmonic balancer, delbrock dual plane with 750 Edelbrock carb, eromotive electric pump, uel system is all Aeroquip with braided lines and has a fuel cell in the back. Full array of Autometer gauges.


C6 race built tranny, 400stall, i energy 1-2 band, ushing kit, hrust washer's, clutch direct drum with torrington bearing's, igh performance clutch's, rans King low gear set with 6 pin steel front planetaries and 4 pin rear planetary, nbsp;2.72 1st, .54 2nd, rans King reverse pattern manual valvebody with billet servo, external perma cool tranny coolers.

Transfer case is an NP205 with new bearings and a seal kit installed.

Ford 9" with 4.88 gears and a Strange supercase and Daytona pinion support, trange chrome moly 1350 yoke, etroit locker, osier shaft's, igh angle Driveline driveshaft with 1350 CV joint,

Dana 44 in front with a 4.56 gears, rac lok limited slip. I have the 4.88 gears for the front axle to match the back, hey are not installed.


Body is in very solid shape. It isstarting to show some blistering around the rear tire carrier mount on the lower side as shown in picture. The driver side door hinge sprung open on a windy day and ending up putting 2 small dents on the edge of the driver side door, ee pictures. The paint was redone around 2003 and still shows very nicely for its age s the pictures show. It has new anti rattler kits and weatherstripping in the driver and passenger doors for thewindows. Exterior mirrors are brand new. Cowl badges are brand new.The interior is in very good condition. There is no heat and no A/C. The prior owner took that off to mount the ignition stuff on the firewall. I'm sureit could be added back on if you wanted to. There is no radio, hen you have a motor that runs this healthy who wants to listen to music! Rear window works fine either by dash switch or key switch in gate.

If you need any other pictures send me a message, can either text them or email them to you.

Reserveis set at a very reasonable price. This Bronco was appraised in 2005 for $14,800 and my reserve is well below that. I require a $500.00 deposit at end of auction and the balance to be paid within7 days from end of auction. Do not bid if you have a 0 feedback rating without messaging me first. If you do not message me your bid will be cancelled.Relisting due to non paying bidder