1988 Ford Mustang GT Fox Body Drag Car - 331 Stroker Turbo - 568rwhp

Condition:	Used
Make:	Ford
Model:	Mustang
Type:	Hatchback
Trim:	GT Hatchback 2-Door
Year:	1988
Mileage:	83,000
VIN:	1FABP42E3JF302519
Fuel:	Gasoline
Drive type:	RWD
Vehicle Title:	Clear
Item location:	Delaware, Ohio, United States

Extras

Listed by

Private seller

Enquire

Description of 1988 Ford Mustang

1988 mustang GT Tangerine Pearl with 88k miles on body, tripped interior, oll cage
Custom tune with SCT chip
Recently Dyno tested 568rwhp 543ft-lb @ 14 psi on 93 pump gas
It's runs and drives, ut still needs minor tuning and mods to unlock it's full potential (upwards of 1000hp, arger turbo, 85 etc), ut we're ready to move on
Note: This is set up as a Drag car! Will need to be transported to destination. Has manual brakes and steering, nd the A1000 fuel pump is not rated for continuous duty.
Engine
Boss block (331 stroker)
Forged 4340 steel crank
Forged 4340 h-beam rods
Forged cp pistons
King bearings
All Arp hardware through short block
Arp head studs
Cometic gaskets
Ford Racing F-303 cam
New lifters/ push rods
Fresh SVO Y303 heads 40# springs
Ford racing 1.6 roller rockers
Mark VII fan
Moroso electric water pump
Chrome upper hose
Moroso 7qt pan
Jegs aluminum two core rad.
EFI
Spyder intake
75mm TB
Abaco 85mm MAF
Power adder
Custom turbo kit 70mm master power turbo
50mm Tial bov
F46 Tial wastgate
Dual 2.5 up pipes
3" Charger pipes
Godspeed 24x3x12 intercooler
Electronics
MSD 6AL Ignition controller
Autometer 5" tach; Boost; Oil pressure gauges
Fuel pressure gauge on rail
Painless toggle panel
Trans
Tremec 3550
Hurst shifter
BBK quadrant, djuster, lutch cable
Steel flywheel
Zoom Stg III clutch
Exhaust
1 5/8 BBK shorties
3.5 down pipe
Dual 2.5 into XR1 race mufflers Turndowns
Rear end
8.8 4.10 Ford racing trac lok Heavy-duty 28 or 31 spline axles (I cant remember)
Trick Flow girdle Suspension
Granatelli Platinum Series K-Member -A-arms -Coil over kit -Caster / Camber Plates 90/10 Lakewood drag struts
Southside solid uppers/ lowers 50/50
Lakewood drag shocks
Fuel system
Aluminum 10 gallon fuel cell
Aeromotive A1000 pump -35 micron filter -100micron filter
A1000 regulator 10an feed 6an return
Billet 5/8 rails 55lb/hr Siemens Deka injectors
Wheels
5-lug swap Centerline 15x4 w/ front-runners 15x8 w/ BFG drag radials
Sold as-is. Buyer is responsible for inspections, ill try my best to accommodate any third party inspection services if buyer chooses to order one.
Links to video of car in action:
https://youtu.be/LzVGCBU5yo8
https://youtu.be/LzXmwa7gNCs
https://youtu.be/IDxybZmL3Sg