1982 CJ8 Jeep Scrambler

Howdy all, I've been working on the jeep for the past 4 years and it's time to part ways, its not the best vehicle for a student.

I need it sold ASAP for school purposes.I'm asking $18,000.00 or BEST OFFER.

The jeep is currently my daily driver and has been rebuilt.

If you have any questions don't hesitate to ask. I've done a lot of work on the jeep, you name it, it's most likely been gonethrough. Since its been completed the Jeep has 600-700 miles on it.

The Jeep is a 1982 CJ8 Jeep Scrambler

The engine is a 256, 4.2L straight 6 Original Engine (has been rebuilt) Along with the engine I've added a few things on to it. Like a HGI distributor, A twin barrel Holley Carb, and a black Aluminum valve cover (the 1982's originally came with a plastic valve cover) .

Trans is a 5 speed manual (Rebuilt), the 4x4 works.

Engine rebuild

Trans. rebuild

Transfer case rebuild

Aluminum valve cover

Removal of smog/ emissions system (will pass inspection)

HGI Distributor

Twin barrel Holley carb

New complete AC unit

New Radiator

Rear drive shaft.

Drive shafts U-joints.

Tires are 33x15x12.5 BFG's only about 600-700 miles on them

Doors have been gone through, they open and close with ease the locks work on them too. Windows also open and close with ease, both cab windows and door windows.

New fly wheel

New pressure plate

New windshield

New windshield wipers

New wiper motor

New oil pressure meter

New volt meter

New fuel pump

New oil sending unit

New Gasgauge

Gas Tank has been pulled and cleaned

New Engine mounts

New spark plugs

Front end has all new tie rods, and bearings along with the hubs being gutted, cleaned, andre-greased.

New Brakes

NewCalipers

New Discs

New Brake lines

Rear ends have been gone through,

New Drums

New Brake pads

New Axles

New Axle seals

The bed and floor boards are sprayed with bed liner as well as the undercarriage andremovable top.

New springs

New shocks

New sway bar mounts.

New body mounts.

Wooden boards are original have been touched up.

Again, if you have any questions please message me. I'll be more than happy to answer any questions you may have.