1967 Pontiac GTO 4 speed Convertible. Clean Texas Car Drive anywhere

This is a stunning, 1967 Pontiac GTO 4 speed Convertible, beautifully restored to as new condition, with minor changes done to enhance drivability and increase safety. I have owned this convertible for 11 years and it has undergone a three year, no expense spared restoration. It is an outstanding example of automotive art that is fantastic to drive and exceeds its reputation for performance and speed. It is very, very fast! Please look closely at the attached photos. The attention to detail and painstaking restoration will speak for itself. The attached photos are only a few of the hundreds that I have taken of the restoration process. I will gladly provide any additional photos or information about the GTO. There are no secrets in this restoration or hidden flaws as seen in many vehicles that are called "restored”. The more you look at the details of this GTO the better it will become! There is not a part or piece on this GTO that was not rebuilt, replaced or restored!

The GTO is a documented GTO convertible, one of 9,517 made in 1967 and one of the 4,313 4 speed GTOs made in that year. Enclosed is factory documentation from the Pontiac Historical Society confirming it is a real GTO convertible. The build sheet confirms the VIN number, the color, options and other critical information. Significantly, the Engine Unit Number is listed on this document and this number matches the number stamped on the right side of the engine block, proving that the GTO still retains its original engine. (Note: the serial number of the vehicle was not stamped on the engine and transmission until government required in 1968). The Muncie 4 speed wide ratio transmission is also original to the car, with a build date of May 4, 1967. Please refer to the attached Build Sheet. The block has a casting number of 9786133, correct for 1967 and a D197 block cast date of April 19, 1967. This provided further verification of the engine' authenticity.

The Pontiac Historical Society also provided documentation referred to as the Wholesale Car Order. It lists options on this GTO as having: an AM Pushbutton Radio; Center Seat Belts; F:70x14 Red Wide Oval Tires, Safe T-Track Rear Axle with 3.55 ratio; 4 speed Fully Synchronized Muncie Transmission. Please refer to the attached Wholesale Car Order.

The original Data Plate is attached to the firewall and decodes as being built the 4th week of May, 1967, assembled in the Baltimore Plant, Black Interior Trim, Regimental Red Exterior Color with a Black Convertible Top. Please refer to the attached Data Plate Decoding.

The GTO's original VIN plate is secured via rivets on the driver's side door frame. The VIN 242677B131321 decodes as a 1967 Pontiac GTO Convertible, built at the Baltimore Assembly Plant.

The Pontiac Historical Society provided an exact reproduction of the Original Window Sticker. It indicates the GTO was delivered to Harry Brown Pontiac, Inc, New Hyde Park, NY, and retailed for a total price of $3,554.66. See attached Window Sticker.

While all GTO's were noted for their performance, special attention was given to the original 400 cubic inch engine, factory rated at 335 horsepower. I had a noted engine builder who specializes in Pontiac engines rebuild the engine. The goal was to be a stock looking engine, but with internals upgraded for performance. To that end, only high quality parts were used. Some of these included light weight forged pistons, Moly rings, ARP bolts, Clevite bearings, Melling oil pump, high performance Comp Cam and push rods. The block was bore honed and blocked, the rotating assembly was blueprinted, balanced and then spin balanced. The original cylinder heads (cast 670) were extensively ported and hardened valve seats installed. Hydraulic rolling rocker arms were installed. The original intake manifold (E017-Date code May 1, 1967) was also ported. It should be noted that the carburetor is a high performance model, it is not correct for a 1967 GTO. The part number of the installed carb is for a 1968 Buick GS or Olds 442.

The other components of the drive train were also refurbished and restored. The 4 speed transmission was rebuilt, the original drive shaft was spin balanced and new U joints installed. The original 3:55 rear was disassembled, sandblasted, epoxy primed and painted black. All seals, gaskets and bearings were replaced.

This attention to detail was given to each part of this GTO. It was totally disassembled. The frame was sandblasted, sprayed in black PPG epoxy paint and painted again in black paint. The body was placed on a rotisserie frame at my residence where it was sandblasted, sealed and painted in multiple coats of base coat/clear coat. I then turned the GTO over to a reputable body shop. There new lower quarter panels, a trunk floor and quarter panel extensions were installed. A reproduction driver's side floor pan was also installed. After extensive blocking and sanding, the GTO was painted in multiple coats of PPG basecoat/clearcoat paint. It was then sanded and buffed multiple times, resulting in a brilliant mirror finish.

I sandblasted all the suspension parts and painted them with PPG epoxy paint. All bushings, wear parts, ball joints, springs, were replaced with Moog quality parts or had polyurethane bushings replace the original rubber parts. All brake parts were replaced, including adding stainless steel brake and fuel lines, rubber hoses, master cylinder and brake booster. The GTO originally came with four wheel manual drum brakes. In interest of safety, the front brakes were converted to power disc brakes, with all brake parts matching original type parts.

Other upgrades were installed on the GTO. It came from the factory equipped with manual steering, but it was converted to power steering, again using original type equipment. It had the standard GTO dash when built. This dash package did not include a tachometer and only warning lights for temperature and oil pressure. The dash was upgraded to the optional woodgrain Rally dash, which now include a full set of gauges as well as a tachometer.

The original wheels and tires were 14 inch with Rally II wheels. These were upgraded to 15 inch tires, with Rally I wheels.

The largest upgrade on the GTO was the conversion of the Black convertible top and interior to a white top and a parchment (off white) interior. I must admit I spent quite a bit of time debating this conversion. However, upon viewing the stunning results, I know it was the right decision. (Especially in Texas!). The white top and parchment interior make this GTO one of the best!

This is a Link to additional Photos and Video :

https://photos.google.com/share/AF1QipNnHY34t5zzjYBWt88kP_SSK9zjcrktyl5P1-XPHYEV7N1carByggKVvWQcgo2Q5A?key=bXU0aVBQVXZ5QzV3alJjcEVQSmxXT3N3TkFicGJ3

This investment quality GTO has undergone an extensive restoration and the attention to details during this process is second to none. It is reasonably priced at $76,500.

Buy this Amazing car with confidenc, no need to transport Fly in and drive this car anywhere.

We will be glad to help with loading if you chose to use a shipping company.

PAYMENT INFORMATION: The car is sold as is, no warranty implied or offered. The successful bidder is required to send a $500 deposit within 24 hours of the end of auction via PayPal (other methods may be used if discussed and agreed upon prior to bidding!). If you are not able or willing to meet these criteria, please do not bid until you have discussed options with me. The balance of the auction is due in full within 7 days of the end of the auction. I prefer PayPal (for the deposit ONLY) and an electronic funds transfer for the balance. I will not accept PayPal for payment of the balance except under special circumstances that must be agreed on prior to bidding. I'll accept other forms of payment such as certified bank check or cashier's check for the balance, but all funds must clear my bank prior to release of the car. I would like the car picked up within 15 days of the end of the auction. The buyer is solely responsible for arranging the pickup of the car.

ZERO (0) FEEDBACK AND NON-U.S. BIDDERS: If you are a zero (0) feedback bidder or a non-U.S. bidder youMUSTcontact me before bidding. I will cancel the bid of any zero feedback or non-U.S. bidder that does not contact me prior to bidding. I will require any zero feedback or non-U.S. bidder to provide me with a verifiable physical address and contact information prior to bidding. I realize we were all zero feedback bidders at some point, but unfortunately zero feedback bidders are often also non-paying bidders on automobile auctions.

BIDDER CONFIDENCE: I strive for the most transparent auction possible. As a bidder, you can be confident that the vehicle you are bidding on is described to the best of my ability. I am always happy to provide any perspective bidder my contact information if they wish to speak directly with me on the telephone about the vehicle. If within driving distance, a perspective bidder is welcome to come see the car in person prior to bidding. I am happy and willing to take any reasonable actions (i.e. additional pictures, telephone conversation, in-person viewing of car prior to conclusion of the auction, etc.) to give the bidder confidence that the vehicle being auctioned is indeed in my possession, for sale, and has been described as accurately as I am able. I will conduct myself in a professional manner throughout the auction process and I will be a prompt communicator via email, telephone or text message.

Thank You

Mopars of Texas